Tuesday, 13 May 2014

All about Post Hole Borer



Post hole borer is also sometimes referred to as a post hole digger. This is basically a tool that is used for small-sized digging projects. This tool works best for jobs that do not require extensive digging. You should know that this tool is not to be confused with a post pounder that is used with a digger. 

A post hole borer usually has a six feet long handle. This handle permits to reach greater depths than the other smaller models that have handles of five feet. The handles are made from hard wood and are then coated in varnish. The varnish coating allows the buyer to actually inspect the condition of the wood. This is good as some manufacturers try to sell inferior quality of products to the buyers for premium prices. Since the handles are rounded it makes them easier to hold.



A good post hole borer bought from Digga Europe will have hardened bladed that are moulded with precision. These blades are sharpened with a lot of care and are covered using a shield during the sharpening process. These blades are specifically designed to dig holes of a certain size; mostly holes of six inches. 

The best part about this drill is that it digs narrow and neat holes. However you should know that this gadget works the best on soft clay surfaces; if you want to use this on gravel then the drilling process may be a little difficult. The post hole borer has a pin that is made from ¾” steel. This is made specially to be durable so that it can last for a long time. As a user you should take care of this pin by coating it with oil so that it does not rust.

Before you start using this digger you should remember all the safety measures; which mean that there should be no pipes, gas lines or electric cables nearby. You should wear gloves when you operate this drill. You should not forget to wear goggles to protect your eyes at all times. Once you are done with the safety measures you should then proceed to mark the area where you wish to drill. 

Then hold the digger above the ground and then just slam it into the surface; after that simply make sure that the handles are apart this will trigger the digger to start digging. Remove the digger and eliminate the dirt from the blades repeat the process until you are satisfied with the depth of the hole.




Now if you have a big project in hand and you require to dig in multiple locations you should then consider going in for the power post hole borer rather than a manual one. You must always remember to buy from a reputed manufacturer. 

Use the internet to locate reputed manufacturers; shortlist a few names and carryout a comparative study on them. You must also take second opinions from friends and family. If you buy the powered model you will need another person to help you out in its operation.
So follow the tips shared in this article and you will have no trouble in handling a post hole borer.

No comments:

Post a Comment